Grail soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 10 to 33 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Grail soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Grail silt loam, 0 to 3 percent slopes, rarley flooded (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 44% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 23 in (59 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 8.1%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 6 in down: about 15% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA A clay loam layer about 6 to 10 in down: about 32% clay, high plasticity when wet, dark gray when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 10 to 33 in down: about 44% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerBk A clay loam layer about 33 to 52 in down: about 36% clay, high plasticity when wet, light brownish gray when moist. Strong lead
- Loamy layerC A clay loam layer about 52 to 79 in down: about 31% clay, high plasticity when wet, grayish brown when moist. Possible
What it looks like raw
The clay subsoil (Bt), 10 to 33 in down in the typical profile: dark gray (10YR 4/1), very dark brown (10YR 2/2) moist; firm. Raw colour is not fired colour.
About the soil
- Parent material: local alluvium derived from shale and siltstone.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Western North Dakota, northwestern South Dakota and eastern Montana. The soil is of large extent.
USDA, geographic setting: Grail soils are on level to strongly sloping terraces, fans, slightly concave swales and foot slopes on uplands. Slope gradients typically are 1 to 3 percent but range from 0 to 15 percent. The soils formed in local alluvium from soft siltstone or shale. Mean annual air temperature is 34 to 45 degrees F, and mean annual precipitation is 12 to 18 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
- Loburn: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Grail silt loam, 0 to 3 percent slopes, rarley flooded, map unit Gr in Meade County, South Dakota, Northern Part.
- Official Series Description: Grail(revised 01/2023), established.
- Taxonomic class: Fine, smectitic, frigid Pachic Vertic Argiustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.