Heil soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 20 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Heil soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Heil silty clay loam (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 41% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (28): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 40 in (101 cm)).
- Note Typically starts within about 20 in (51 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A silty clay loam layer about 0 to 3 in down: about 31% clay, moderate plasticity when wet, dark gray when moist. Possible
- Clay-rich layerH2 A clay layer about 3 to 20 in down: about 53% clay, high plasticity when wet, very dark gray when moist. Strong lead
- Clay-rich layerH3best layer A clay layer about 20 to 60 in down: about 41% clay, high plasticity when wet, dark gray when moist. Strong lead
What it looks like raw
The clay-rich layer (H3), 20 to 60 in down in the typical profile: dark gray (5Y 4/1), light gray (5Y 6/1) dry; extremely hard, very firm. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Western North Dakota, eastern Montana, and northwestern South Dakota. The soil is of moderate extent.
USDA, geographic setting: Heil soils are in level shallow lake basins and flat enclosed uplands depressions. Slope ranges from 0 to 1 percent. The soils formed in clayey calcareous alluvium. Mean annual air temperature ranges from 34 to 45 degrees F, and mean annual precipitation from 12 to 18 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
- Loburn: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Heil silty clay loam, map unit He in Meade County, South Dakota, Northern Part.
- Official Series Description: Heil, established.
- Taxonomic class: Fine, smectitic, frigid Typic Natraquerts
- Rated with rule version 2026-09-28.1; the method is on the About page.