Widewater soil
Wild-clay potential
Possible
Possible: a clayey layer typically about 67 to 70 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Widewater soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Widewater spot on the map
Rated from the USDA soil survey record for Widewater and Issue soils, frequently flooded (Prince George's County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Lowers the potential Thin layer (about 3 in (8 cm)), hard to collect in quantity.
- Lowers the potential Typically starts about 67 in (170 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilAg A loam layer about 0 to 4 in down: about 17% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerBg A fine sandy loam layer about 4 to 8 in down: about 18% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerBCg A loam layer about 8 to 44 in down: about 20% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilAgb A loam layer about 44 to 67 in down: about 22% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- Clay-rich layerCgbest layer A clay layer about 67 to 70 in down: about 45% clay, high plasticity when wet, dark grayish green when moist. Possible
What it looks like raw
The clay-rich layer (Cg), 67 to 70 in down in the typical profile: dark grayish green (5G 3/2); clay; firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Maryland, in these survey areas: Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Howell: Strong lead
- Lenni: Strong lead
- Magnolia: Strong lead
- Aquasco: Promising
- Chillum: Promising
- Dodon: Promising
- Elkton: Promising
See it on the map
Open a Widewater spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 41%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Widewater and Issue soils, frequently flooded, map unit WE in Prince George's County, Maryland.
- Official Series Description: Widewater(revised 11/2015), established.
- Taxonomic class: Fine-loamy, mixed, active, acid, mesic Fluvaquentic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.