Dodon soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 9 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dodon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Dodon fine sandy loam, 0 to 2 percent slopes (Prince George's County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (11).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 9 in down: about 10% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay subsoilBtbest layer A sandy clay loam layer about 9 to 36 in down: about 30% clay, moderate plasticity when wet, dark yellowish brown when moist. Promising
- Loamy layerBC A sandy clay loam layer about 36 to 48 in down: about 23% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerCB A fine sandy loam layer about 48 to 64 in down: about 12% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 9 to 36 in down in the typical profile: dark yellowish brown (10YR 4/6); friable; slightly sticky; slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy fluviomarine deposits.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maryland, in these survey areas: Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Distribution: Inner (Northern) Coastal Plain of southern Maryland, primarily the Miocene age Calvert Formation
USDA, geographic setting: Landscape: Mid-Atlantic Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Howell: Strong lead
- Lenni: Strong lead
- Magnolia: Strong lead
- Aquasco: Promising
- Chillum: Promising
- Elkton: Promising
- Liverpool: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 70%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dodon fine sandy loam, 0 to 2 percent slopes, map unit DfA in Prince George's County, Maryland.
- Official Series Description: Dodon(revised 11/2015), established.
- Taxonomic class: Fine-loamy, siliceous, semiactive, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.