Wellsboro soil
Wild-clay potential
Weak indication
Weak indication: no layer of Wellsboro shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Wellsboro soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Wellsboro spot on the map
Rated from the USDA soil survey record for Wellsboro channery silt loam, 3 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 33 in (85 cm)).
- Note Typically starts within about 22 in (55 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A channery silt loam layer about 0 to 8 in down: about 16% clay, moderate plasticity when wet, dark reddish gray when moist. Weak indication
- Sandy layerBw A channery silt loam layer about 8 to 22 in down: about 14% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBxbest layer A channery loam layer about 22 to 55 in down: about 16% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerC A very channery loam layer about 55 to 72 in down: about 13% clay, moderate plasticity when wet, weak red when moist. Weak indication
What it looks like raw
The sandy layer (Bx), 22 to 55 in down in the typical profile: reddish brown (5YR 5/3); very channery loam; firm; brittle. Raw colour is not fired colour.
About the soil
- Parent material: loamy till from reddish sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in New York, in these survey areas: Delaware County, New York; Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: The glaciated Allegheny Plateau of northwestern New Jersey, southern New York and northern Pennsylvania. The acreage of Wellsboro is almost entirely within MLRA 140. Small acreage occurs in transitional areas that border MLRA 140. The series is extensive.
USDA, geographic setting: Wellsboro soils are on nearly level to steep glaciated uplands. Slope ranges from 0 to 50 percent. The soils developed in firm till derived from reddish sandstone, siltstone, and shale. Mean annual temperature ranges from 6 to 11 degrees C (43 to 52 degrees F). Mean annual precipitation ranges from 795 to 1725 mm (31 to 68 in), and mean annual frost-free season ranges from 105 to 180 days. These soils generally occur at elevations between 100 and 670 m (328 and 2,198 ft), but have been mapped as high as 750 m (2,460 ft) in some areas.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lakemont: Strong lead
- Phelps: Strong lead
- Holly: Promising
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Lackawanna: Weak indication
- Lordstown: Weak indication
See it on the map
Open a Wellsboro spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Wellsboro channery silt loam, 3 to 8 percent slopes, map unit WeB in Delaware County, New York.
- Official Series Description: Wellsboro(revised 09/2015), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Typic Fragiudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.