Vergas soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 10 to 25 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Vergas soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Vergas loam, 0 to 3 percent slopes (Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (7.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 15 in (39 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 28% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 5 in down: about 18% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerH2 A loam layer about 5 to 10 in down: about 25% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH3best layer A clay loam layer about 10 to 25 in down: about 28% clay, moderate plasticity when wet, pale brown when moist. Possible
- Loamy layerH4 A gravelly loam layer about 25 to 29 in down: about 25% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH5 An extremely gravelly loamy sand layer about 29 to 60 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The loamy layer (H3), 10 to 25 in down in the typical profile: pale brown (10YR 6/3), dark brown (10YR 3/3) moist; hard, friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: old alluvium derived from volcanic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Central Oregon east of the Cascade Mountains; MLRA 23. The series is of minor extent.
USDA, geographic setting: Vergas soils are on fan terraces, depressions on plateaus and lake terraces at elevations of 4,100 to 6,000 feet. Slopes range from 0 to 8 percent. The soils formed in stratified loamy and sandy sediments and alluvium weathered from lava rocks and ash with minor amounts of eolian material. The climate is characterized by warm dry summers and cold moist winters. The mean annual precipitation is 10 to 12 inches. The mean annual temperature is 43 to 45 degrees F, average January temperature is 27 to 29 degrees F, and average July temperature is 59 to 61 degrees F. The frost-free period is 50 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Moonbeam: Strong lead
- Swalesilver: Strong lead
- Ninemile: Promising
- Reluctan: Promising
- Goodtack: Possible
- Hackleman: Possible
- Bluesters: Weak indication
- Borobey: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Vergas loam, 0 to 3 percent slopes, map unit 154A in Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
- Official Series Description: Vergas(revised 02/2005), established.
- Taxonomic class: Fine-loamy over sandy or sandy-skeletal, mixed, superactive, frigid Durinodic Xeric Haplargids
- Rated with rule version 2026-09-28.1; the method is on the About page.