Bluesters soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bluesters shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bluesters soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bluesters spot on the map
Rated from the USDA soil survey record for Bluesters gravelly sandy loam, 15 to 50 percent slopes (Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 0% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 44 in (111 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Lowers the potential High rock content (about 90% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly sandy loam layer about 0 to 16 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2best layer A cinders layer about 16 to 60 in down: about 0% clay, low plasticity when wet, black when moist. Weak indication
What it looks like raw
The sandy layer (H2), 16 to 60 in down in the typical profile: black (N 2/0), and dark reddish brown (5YR 3/4) moist. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over cinders.
- USDA family particle-size class: ashy over pumiceous or cindery.
- Drainage: excessively drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Cinder cones east of the Cascades in central Oregon; MLRA 6. The series is not extensive.
USDA, geographic setting: The Bluesters soils are on cinder cones at elevations of 3,000 to 5,100 feet. These soils formed in ash and cinders. The climate is characterized by cold, wet winters and hot, dry summers. The mean annual precipitation is 12 to 40 inches, falling mostly as snow. The mean annual temperature is 41 to 47 degrees F. The frost-free period is 30 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Moonbeam: Strong lead
- Swalesilver: Strong lead
- Ninemile: Promising
- Reluctan: Promising
- Goodtack: Possible
- Hackleman: Possible
- Vergas: Possible
- Borobey: Weak indication
See it on the map
Open a Bluesters spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bluesters gravelly sandy loam, 15 to 50 percent slopes, map unit 18D in Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
- Official Series Description: Bluesters(revised 09/2011), established.
- Taxonomic class: Ashy over pumiceous or cindery, glassy, frigid Humic Vitrixerands
- Rated with rule version 2026-09-28.1; the method is on the About page.