Tyler soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 19 to 50 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tyler soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tyler silt loam (Huntingdon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 32% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 9 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerH2 A silty clay loam layer about 9 to 19 in down: about 32% clay, moderate plasticity when wet, light yellowish brown when moist. Promising
- Loamy layerH3best layer A silty clay loam layer about 19 to 50 in down: about 32% clay, moderate plasticity when wet, light yellowish brown when moist. Promising
- Loamy layerH4 A stratified gravelly loam to silty clay loam layer about 50 to 60 in down: about 21% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (H3), 19 to 50 in down in the typical profile: light yellowish brown (10YR 6/4); very firm, brittle. Raw colour is not fired colour.
About the soil
- Parent material: old alluvium derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Pennsylvania, in these survey areas: Huntingdon County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Ohio, West Virginia, Kentucky, Tennessee, Maryland and Pennsylvania. The series is of moderate extent in MLRA's 121, 124, 125, 126, 127, 128, and 147.
USDA, geographic setting: Tyler soils formed in silty alluvium and a mantle of loess on stream terraces. Slope gradients range from 0 to 8 percent. Climate is humid and temperate. Mean annual precipitation ranges from about 914 to 1143 millimeters, and mean annual air temperature ranges from about 9 to 13 degrees C. Frost free days range from 145 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Edom: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Brinkerton: Promising
- Ernest: Promising
- Newark: Promising
- Albrights: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tyler silt loam, map unit Ty in Huntingdon County, Pennsylvania.
- Official Series Description: Tyler(revised 04/2025), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Aeric Fragiaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.