Albrights soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 22 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Albrights soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Albrights spot on the map
Rated from the USDA soil survey record for Albrights silt loam, 3 to 8 percent slopes (Huntingdon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 29% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (9).
- Note The official series description calls the wet soil nonsticky and slightly plastic.
- Note Thick enough to investigate (about 38 in (96 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Loamy layerH1 A gravelly silt loam layer about 0 to 10 in down: about 21% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerH2 A gravelly silt loam layer about 10 to 22 in down: about 27% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerH3best layer A gravelly silty clay loam layer about 22 to 60 in down: about 29% clay, moderate plasticity when wet, reddish brown when moist. Possible
What it looks like raw
The loamy layer (H3), 22 to 60 in down in the typical profile: reddish brown (2.5YR 4/4); nonsticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from acid, red sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Centre County, Pennsylvania; Huntingdon County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Appalachian ridge and valley, Allegheny Plateau and Mountains and surrounding glaciated areas of Pennsylvania. Also in ridge and valley areas of Maryland, West Virginia, and possibly Virginia. MLRA's 127, 140, 147. The series is of large extent.
USDA, geographic setting: Albrights soils are on nearly level to moderately steep concave hillsides on footslopes, toeslopes, and in U-shaped drainage heads. Slopes range from 0 to 25 percent. Albrights soils formed in a regolith of colluvium or glacial till from reddish shale, siltstone and fine grained sandstone. The climate is temperate and humid, with mean annual precipitation of 950 to 1350 millimeters; average annual temperature ranges from 8.5 degrees to 10.5 degrees C., and the frost free growing season is 140 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hublersburg: Strong lead
- Opequon: Strong lead
- Dunning: Strong lead
- Edom: Strong lead
- Hagerstown: Strong lead
- Millheim: Strong lead
- Purdy: Strong lead
- Brinkerton: Promising
See it on the map
Open a Albrights spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Albrights silt loam, 3 to 8 percent slopes, map unit AbB in Huntingdon County, Pennsylvania.
- Official Series Description: Albrights(revised 07/2025), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Aquic Fragiudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.