Tunkhannock soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tunkhannock shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tunkhannock soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tunkhannock spot on the map
Rated from the USDA soil survey record for Tunkhannock gravelly loam, 0 to 3 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (1): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 47 in (119 cm)).
- Note Typically starts about 25 in (64 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 55% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A gravelly loam layer about 0 to 6 in down: about 12% clay, slightly plastic when wet, brown when moist. Weak indication
- Sandy layerBw1 A gravelly loam layer about 6 to 8 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw2 A very gravelly loam layer about 8 to 18 in down: about 12% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBC A very gravelly sandy loam layer about 18 to 25 in down: about 10% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layer2Cbest layer A very gravelly loamy coarse sand layer about 25 to 72 in down: about 5% clay, low plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The sandy layer (2C), 25 to 72 in down in the typical profile: reddish brown (5YR 4/3); loose, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: gravelly loamy glaciofluvial deposits over sandy and gravelly glaciofluvial deposits, derived mainly from reddish sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 14 map units in New York, in these survey areas: Delaware County, New York; Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Northern Pennsylvania, New Jersey, and New York. MLRA 140 and 144A. The series is moderately extensive. Pennsylvania has about 5,000 acres; New York has more than 20,000 acres.
USDA, geographic setting: Tunkhannock soils are nearly level to very steep soils on glacial outwash terraces, kames, and valley trains. Slope ranges from 0 to 60 percent. The soils formed in water sorted glacial material derived from reddish sandstone, siltstone, and shale. The climate is humid and temperate. Mean annual precipitation ranges from 35 to 45 inches, mean annual temperature ranges from 45 to 55 degrees F., and the frost free period ranges from 130 to 180 days. Elevation ranges from about 800 to 1800 feet.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lakemont: Strong lead
- Phelps: Strong lead
- Holly: Promising
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Lackawanna: Weak indication
- Lordstown: Weak indication
See it on the map
Open a Tunkhannock spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tunkhannock gravelly loam, 0 to 3 percent slopes, map unit TkA in Delaware County, New York.
- Official Series Description: Tunkhannock(revised 04/2002), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.