Tunbridge soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tunbridge shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tunbridge soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tunbridge spot on the map
Rated from the USDA soil survey record for Tunbridge-Lyman-Rock outcrop complex, 0 to 8 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (1): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Organic top layerOe An organic top layer about 0 to 3 in down, not a clay body. Weak indication
- Organic top layerOa An organic top layer about 3 to 5 in down, not a clay body. Weak indication
- Sandy layerE A fine sandy loam layer about 5 to 8 in down: about 4% clay, low plasticity when wet, dark gray when moist. Weak indication
- Sandy layerBhs A fine sandy loam layer about 8 to 11 in down: about 7% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBsbest layer A fine sandy loam layer about 11 to 26 in down: about 4% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBC A fine sandy loam layer about 26 to 28 in down: about 4% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- BedrockR Bedrock about 28 to 38 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (Bs), 11 to 26 in down in the typical profile: dark reddish brown (5YR 3/3), and reddish brown (5YR 4/4); fine sandy loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy supraglacial till derived from granite and gneiss and/or loamy supraglacial till derived from phyllite and/or loamy supraglacial till derived from mica schist.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 28 in (71 cm) down.
Where it is mapped
Seen on the map as the most common soil in 15 map units in Maine, New Hampshire, Vermont, in these survey areas: Coos County Area, New Hampshire; Franklin County Area and Part of Somerset County, Maine; Washington County, Vermont.
By state: wild clay in Maine,wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: Vermont, Maine, Massachusetts, New Hampshire, and New York. MLRAs 143, 144A, and 144B. The series is extensive.
USDA, geographic setting: Tunbridge soils are on nearly level to very steep glaciated uplands. They are on the tops and sides of hills and mountains. Slope ranges from 0 to 80 percent. The soils formed in loamy supraglacial till of Wisconsin age derived mainly from micaceous schist, gneiss, phyllite, granite, and meta-anorthosite. The mean annual precipitation is 790 to 2420 mm, and the mean annual temperature is -3 to 7 degrees C. The frost-free period is from 60 to 160 days. Elevation ranges from about 2 to 800 meters above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Swanville: Possible
- Adams: Weak indication
- Colton: Weak indication
- Nicholville: Weak indication
- Peru: Weak indication
- Berkshire: Weak indication
See it on the map
Open a Tunbridge spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 41%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tunbridge-Lyman-Rock outcrop complex, 0 to 8 percent slopes, map unit 61B in Coos County Area, New Hampshire.
- Official Series Description: Tunbridge(revised 01/2016), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.