Peru soil
Wild-clay potential
Weak indication
Weak indication: no layer of Peru shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Peru soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tunbridge-Peru complex, 3 to 8 percent slopes, rocky (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 6 in down: about 6% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBhs A fine sandy loam layer about 6 to 8 in down: about 6% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBs1 A fine sandy loam layer about 8 to 12 in down: about 3% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBs2 A fine sandy loam layer about 12 to 18 in down: about 3% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerBs3 A fine sandy loam layer about 18 to 21 in down: about 1% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerBC A fine sandy loam layer about 21 to 24 in down: about 1% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerCdbest layer A sandy loam layer about 24 to 65 in down: about 3% clay, low plasticity when wet, olive brown when moist. Weak indication
What it looks like raw
The sandy layer (Cd), 24 to 65 in down in the typical profile: olive brown (2.5Y 4/3); firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy lodgment till derived from granite and/or mica schist and/or phyllite.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 28 map units in Maine, New Hampshire, Vermont, in these survey areas: Addison County, Vermont; Carroll County Area, New Hampshire; Chittenden County, Vermont; Coos County Area, New Hampshire; Franklin County Area and Part of Somerset County, Maine; Kennebec County, Maine; Somerset County Area and Parts of Franklin and Oxford Counties, Maine; Somerset County, Maine, Southern Part; Washington County, Vermont.
By state: wild clay in Maine,wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: Maine, Massachusetts, New Hampshire, New York, and Vermont. The soils of this series are extensive.
USDA, geographic setting: Peru soils are on nearly level to steep slopes in glaciated uplands. Typically they are on linear or convex areas of backslopes, footslopes, and toeslopes, but they also occur in concave positions. The soils formed in loamy lodgment till derived mainly from schist, gneiss, phyllite, and granite. Slope ranges from 0 to 60 percent. The mean annual precipitation is 790 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost-free period ranges from 90 to 160 days. Elevation ranges from about 2 to 800 meters above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Biddeford: Strong lead
- Melrose: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Covington: Strong lead
- Livingston: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 41%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tunbridge-Peru complex, 3 to 8 percent slopes, rocky, map unit 470B in Coos County Area, New Hampshire.
- Official Series Description: Peru(revised 06/2016), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Aquic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.