Biddeford soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 16 to 45 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Biddeford soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Biddeford spot on the map
Rated from the USDA soil survey record for Biddeford mucky peat, 0 to 3 percent slopes (Kennebec County, Maine) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (31): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 29 in (73 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Organic top layerOe An organic top layer about 0 to 12 in down, not a clay body. Weak indication
- Loamy layerEg A silt loam layer about 12 to 16 in down: about 26% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- Clay-rich layerBgbest layer A silty clay layer about 16 to 45 in down: about 43% clay, high plasticity when wet, light bluish gray when moist. Strong lead
- Clay-rich layerCg A clay layer about 45 to 65 in down: about 55% clay, high plasticity when wet, light bluish gray when moist. Strong lead
What it looks like raw
The clay-rich layer (Bg), 16 to 45 in down in the typical profile: light bluish gray (10B 7/1); friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: organic material over glaciomarine deposits.
- USDA family mineralogy: illitic.
- USDA family particle-size class: fine.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Maine, in these survey areas: Kennebec County, Maine; Somerset County, Maine, Southern Part.
By state: wild clay in Maine.
USDA, distribution and extent: Dominantly in Maine but the extent includes Massachusetts, New Hampshire, eastern New York, and Vermont (MLRAs 143 and 144B). The series is of large extent.
USDA, geographic setting: Biddeford soils are on coastal lowlands and in river valleys. Slope ranges from 0 to 3 percent. The soils formed in fine textured glaciolacustrine or glaciomarine deposits. The climate is humid and cool temperate. The mean annual temperature ranges from 5 to 7 degrees C, and mean annual precipitation ranges from 860 to 1,320 mm. The frost-free season ranges from 90 to 160 days. Elevation ranges from 2 to 275 m above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Melrose: Strong lead
- Berkshire: Weak indication
- Charles: Weak indication
- Lyman: Weak indication
See it on the map
Open a Biddeford spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 82%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Biddeford mucky peat, 0 to 3 percent slopes, map unit Bo in Kennebec County, Maine.
- Official Series Description: Biddeford(revised 02/2015), established.
- Taxonomic class: Fine, illitic, nonacid, frigid Histic Humaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.