Berkshire soil
Wild-clay potential
Weak indication
Weak indication: no layer of Berkshire shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Berkshire soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Berkshire spot on the map
Rated from the USDA soil survey record for Berkshire, Monadnock, and Hermon soils, 15 to 35 percent slopes, extremely bouldery (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts about 33 in (84 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- TopsoilA A fine sandy loam layer about 2 to 4 in down: about 2% clay, low plasticity when wet, very dark gray when moist. Weak indication
- Sandy layerE A fine sandy loam layer about 4 to 5 in down: about 2% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layerBs1 A fine sandy loam layer about 5 to 7 in down: about 2% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBs2 A fine sandy loam layer about 7 to 13 in down: about 2% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerBs3 A fine sandy loam layer about 13 to 21 in down: about 2% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerBC1 A fine sandy loam layer about 21 to 28 in down: about 2% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Sandy layerBC2 A fine sandy loam layer about 28 to 33 in down: about 2% clay, low plasticity when wet, olive when moist. Weak indication
- Sandy layerCbest layer A fine sandy loam layer about 33 to 65 in down: about 2% clay, low plasticity when wet, olive when moist. Weak indication
What it looks like raw
The sandy layer (C), 33 to 65 in down in the typical profile: olive (5Y 5/3); fine sandy loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy supraglacial meltout till derived from granite and gneiss and/or mica schist and/or phyllite.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 31 map units in Maine, New Hampshire, Vermont, in these survey areas: Addison County, Vermont; Carroll County Area, New Hampshire; Coos County Area, New Hampshire; Kennebec County, Maine; Somerset County, Maine, Southern Part; Washington County, Vermont.
By state: wild clay in Maine,wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: Maine, western Massachusetts, New Hampshire, New York, and Vermont; principally in the White and Green Mountains, the Berkshire Hills, the Vermont Piedmont, and the Northeast Highlands of Vermont; MLRAs 143 and 144B. The series is extensive.
USDA, geographic setting: Berkshire soils are on nearly level to very steep slopes of hills and mountains on glaciated uplands. They are typically on convex parts of summits, shoulders, and backslopes. The soils formed in loamy, late Wisconsin aged, melt-out till derived mainly from schist, granite, gneiss, and phylitte. Slope ranges from 0 to 80 percent. The mean annual precipitation is 790 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost-free period ranges from 90 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Biddeford: Strong lead
- Melrose: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Covington: Strong lead
- Livingston: Strong lead
See it on the map
Open a Berkshire spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 31%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Berkshire, Monadnock, and Hermon soils, 15 to 35 percent slopes, extremely bouldery, map unit 273E in Coos County Area, New Hampshire.
- Official Series Description: Berkshire(revised 05/2016), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.