Livingston soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 7 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Livingston soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Livingston spot on the map
Rated from the USDA soil survey record for Livingston clay (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 75% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 29 in (73 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Clay-rich layerH1 A clay layer about 0 to 7 in down: about 63% clay, high plasticity when wet, black when moist. Strong lead
- Clay-rich layerH2best layer A clay layer about 7 to 36 in down: about 75% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerH3 A clay layer about 36 to 46 in down: about 75% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Clay-rich layerH4 A clay layer about 46 to 62 in down: about 75% clay, high plasticity when wet, dark gray when moist. Strong lead
What it looks like raw
The clay-rich layer (H2), 7 to 36 in down in the typical profile: dark gray (N 4/0); plastic, sticky. Raw colour is not fired colour.
About the soil
- Parent material: clayey glaciolacustrine deposits.
- USDA family mineralogy: illitic.
- USDA family particle-size class: very-fine.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Vermont, in these survey areas: Addison County, Vermont.
By state: wild clay in Vermont.
USDA, distribution and extent: Vermont, New Jersey, and New York. MLRA's 142 and 144A. The series is of moderate extent.
USDA, geographic setting: Livingston soils are nearly level soils on glacial lake plains. They are in depressions and drainageways. Slope ranges from 0 to 3 percent. These soils formed in calcareous estuarine and glaciolacustrine clays. The mean annual precipitation ranges from 26 to 36 inches and the mean annual temperature ranges from 45 to 52 degrees Fahrenheit. The frost-free season ranges from 130 to 165 days. Elevations range from 50 to 1000 feet above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Covington: Strong lead
- Melrose: Strong lead
- Swanton: Strong lead
- Vergennes: Strong lead
- Elmwood: Promising
- Canandaigua: Possible
- Farmington: Possible
- Adams: Weak indication
See it on the map
Open a Livingston spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Livingston clay, map unit Lh in Addison County, Vermont.
- Official Series Description: Livingston(revised 07/2006), established.
- Taxonomic class: Very-fine, mixed, active, nonacid, mesic Mollic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.