Elmwood soil
Wild-clay potential
Promising
Promising: a clayey layer typically about 32 to 72 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Elmwood soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Elmwood spot on the map
Rated from the USDA soil survey record for Elmwood fine sandy loam, coarse variant, 0 to 8 percent slopes (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (17.5).
- Note Thick enough to investigate (about 40 in (102 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 5% calcium carbonate; lime in a clay body deserves testing.
- Missing data Held at "Promising" because no plasticity evidence is available; a high clay percentage alone does not make a strong lead.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 8 in down: about 7% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2 A loamy fine sand layer about 8 to 32 in down: about 2% clay, low plasticity when wet, pale olive when moist. Weak indication
- Clay-rich layerH3best layer A clay loam layer about 32 to 72 in down: about 35% clay, moderate plasticity when wet, olive when moist. Promising
What it looks like raw
The clay-rich layer (H3), 32 to 72 in down in the typical profile: olive (5Y 4/3); firm. Raw colour is not fired colour.
About the soil
- Parent material: sandy glaciolacustrine deposits over clayey glaciolacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy over clayey.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Vermont, in these survey areas: Addison County, Vermont.
By state: wild clay in Vermont.
USDA, distribution and extent: Maine, Massachusetts, New Hampshire, Vermont, and eastern New York; MLRA'S 101, 141, 142, 143, 144A, 144B and 145 (SEE REMARKS). The soil is of moderate extent.
USDA, geographic setting: Elmwood soils are on glaciolacustrine, marine or outwash plains and deltas. Slope ranges from 0 to 25 percent. These soils formed in loamy outwash or lacustrine materials underlain by fine-textured lacustrine or marine deposits. The climate is humid and cool temperate. Mean annual temperature ranges from 43 to 46 degrees F, and the mean annual precipitation ranges from 38 to 55 inches. The frost-free season ranges from 130 to 190 days. Elevation ranges from 5 to 900 feet above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Covington: Strong lead
- Livingston: Strong lead
- Melrose: Strong lead
- Swanton: Strong lead
- Vergennes: Strong lead
- Canandaigua: Possible
- Farmington: Possible
- Adams: Weak indication
See it on the map
Open a Elmwood spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Elmwood fine sandy loam, coarse variant, 0 to 8 percent slopes, map unit ElB in Addison County, Vermont.
- Official Series Description: Elmwood(revised 01/2000), established.
- Taxonomic class: Coarse-loamy over clayey, mixed over illitic, superactive, frigid Aquic Dystric Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.