Buxton soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 35 to 65 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Buxton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Buxton silt loam, 8 to 15 percent slopes (Kennebec County, Maine) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 44% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (31): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerBw1 A silt loam layer about 7 to 18 in down: about 23% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Loamy layerBw2 A silty clay loam layer about 18 to 23 in down: about 32% clay, high plasticity when wet, light olive brown when moist. Possible
- Clay-rich layerBC A silty clay loam layer about 23 to 35 in down: about 38% clay, high plasticity when wet, olive when moist. Strong lead
- Clay-rich layerCbest layer A silty clay layer about 35 to 65 in down: about 44% clay, high plasticity when wet, olive gray when moist. Strong lead
What it looks like raw
The clay-rich layer (C), 35 to 65 in down in the typical profile: olive gray (5Y 4/2); silty clay; very firm. Raw colour is not fired colour.
About the soil
- Parent material: fine glaciomarine deposits.
- USDA family mineralogy: illitic.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maine, Vermont, in these survey areas: Kennebec County, Maine; Somerset County, Maine, Southern Part; Washington County, Vermont.
By state: wild clay in Maine,wild clay in Vermont.
USDA, distribution and extent: Maine, Massachusetts, New Hampshire, New York, and Vermont. The series is of large extent.
USDA, geographic setting: Buxton soils are on coastal lowlands and river valleys. Slope ranges from 3 to 50 percent. The soils formed in medium, moderately fine, and fine textured glaciolacustrine or glaciomarine deposits. The climate is humid and cool temperate. Mean annual precipitation ranges from 860 to 1220 mm, and mean annual temperature ranges from 6 to 8 degrees C. The frost-free season ranges from 90 to 160 days. Elevation ranges from 2 to 274 meters above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lamoine: Strong lead
- Biddeford: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Melrose: Strong lead
- Berkshire: Weak indication
- Peru: Weak indication
- Adams: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Buxton silt loam, 8 to 15 percent slopes, map unit BuC2 in Kennebec County, Maine.
- Official Series Description: Buxton(revised 12/2015), established.
- Taxonomic class: Fine, illitic, frigid Aquic Dystric Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.