Charles soil
Wild-clay potential
Weak indication
Weak indication: no layer of Charles shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Charles soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Charles spot on the map
Rated from the USDA soil survey record for Charles silt loam, 0 to 2 percent slopes, frequently flooded (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 57 in (146 cm)).
- Note Typically starts within about 7 in (19 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 7 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerCgbest layer A silt loam layer about 7 to 65 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (Cg), 7 to 65 in down in the typical profile: dark grayish brown (2.5Y 4/2); friable. Raw colour is not fired colour.
About the soil
- Parent material: coarse-silty alluvium derived from metasedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maine, New Hampshire, in these survey areas: Coos County Area, New Hampshire; Kennebec County, Maine; Somerset County, Maine, Southern Part.
By state: wild clay in Maine,wild clay in New Hampshire.
USDA, distribution and extent: Maine, New Hampshire, New York and Vermont.(MLRA's 143, 144B, and 146) The series is of moderate extent.
USDA, geographic setting: Charles soils are on flood plains that are commonly in broad depressions. Slope ranges from 0 to 2 percent. These soils formed in recent alluvial deposits. Flooding generally occurs once or twice annually, but may occur less often than once in 2 years in some places. Overflow generally occurs during spring runoff and during heavy rains. The climate is humid and cool temperate. The mean annual precipitation ranges from 864 to 1219 mm, and the mean annual temperature ranges from about 3 to 8 degrees C. The frost-free season ranges from 80 to 160 days. Elevation ranges from 3 to 610 m above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Biddeford: Strong lead
- Buxton: Strong lead
- Lamoine: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Melrose: Strong lead
- Berkshire: Weak indication
- Lyman: Weak indication
See it on the map
Open a Charles spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Charles silt loam, 0 to 2 percent slopes, frequently flooded, map unit 209A in Coos County Area, New Hampshire.
- Official Series Description: Charles(revised 09/2013), established.
- Taxonomic class: Coarse-silty, mixed, superactive, nonacid, frigid Aeric Fluvaquents
- Rated with rule version 2026-09-28.1; the method is on the About page.