Colton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Colton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Colton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Colton gravelly sandy loam, 0 to 3 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 1% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 41 in (105 cm)).
- Note Typically starts within about 24 in (60 cm) of the surface.
- Lowers the potential High rock content (about 60% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A gravelly sandy loam layer about 0 to 7 in down: about 6% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBs A gravelly loamy sand layer about 7 to 14 in down: about 3% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBC A very gravelly coarse sand layer about 14 to 24 in down: about 2% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerCbest layer An extremely gravelly coarse sand layer about 24 to 65 in down: about 1% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 24 to 65 in down in the typical profile: pale brown (10YR 6/3), and grayish brown (10YR 5/2); stratified extremely gravelly sand; loose. Raw colour is not fired colour.
About the soil
- Parent material: sandy-skeletal glaciofluvial deposits.
- USDA family particle-size class: sandy-skeletal.
- Drainage: excessively drained.
Where it is mapped
Seen on the map as the most common soil in 19 map units in Maine, New Hampshire, Vermont, in these survey areas: Addison County, Vermont; Chittenden County, Vermont; Coos County Area, New Hampshire; Franklin County Area and Part of Somerset County, Maine; Somerset County Area and Parts of Franklin and Oxford Counties, Maine; Somerset County, Maine, Southern Part; Washington County, Vermont.
By state: wild clay in Maine,wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: MLRAs 141, 142, 143, and 144B in the states of Maine, New Hampshire, Northern New York, and Vermont. The series is extensive.
USDA, geographic setting: Colton soils are on glacial outwash terraces, plains, kames, and eskers. Slope ranges from 0 to 70 percent. The soils formed in water-sorted sand, gravel, cobbles, and stones typically derived from granite with lesser amounts of sandstone and schist. Mean annual temperature ranges from 3 to 7 degrees C (38 to 46 degrees F), mean annual precipitation ranges from 76 to 127 cm (30 to 50 in), and mean annual frost-free days ranges from 90 to 160 days. Elevation ranges from 1.5 to 914 m (5 to 3000 ft) above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Melrose: Strong lead
- Biddeford: Strong lead
- Covington: Strong lead
- Livingston: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Colton gravelly sandy loam, 0 to 3 percent slopes, map unit 22A in Coos County Area, New Hampshire.
- Official Series Description: Colton(revised 02/2017), established.
- Taxonomic class: Sandy-skeletal, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.