Nicholville soil
Wild-clay potential
Weak indication
Weak indication: no layer of Nicholville shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nicholville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Nicholville spot on the map
Rated from the USDA soil survey record for Nicholville very fine sandy loam, 0 to 3 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- Organic top layerOa An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerE A very fine sandy loam layer about 2 to 3 in down: about 5% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBs A very fine sandy loam layer about 3 to 19 in down: about 5% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBC A very fine sandy loam layer about 19 to 30 in down: about 5% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerCbest layer A loamy very fine sand layer about 30 to 65 in down: about 3% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 30 to 65 in down in the typical profile: grayish brown (10YR 5/2); firm. Raw colour is not fired colour.
About the soil
- Parent material: coarse-silty glaciolacustrine deposits.
- USDA family particle-size class: coarse-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Maine, New Hampshire, Vermont, in these survey areas: Coos County Area, New Hampshire; Franklin County Area and Part of Somerset County, Maine; Washington County, Vermont.
By state: wild clay in Maine,wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: The northern border and local areas in the interior of the Adirondack highlands of New York and in Maine, New Hampshire, and Vermont; MLRAs 142. 143, 144B, and 146. The series is moderately extensive.
USDA, geographic setting: Nicholville soils are on nearly level to sloping planar or concave landscapes. They are on lake plains and upland till plains that have a mantle of wind or water-deposited silt or very fine sand. Normally, slopes range from 0 to 15 percent, but may range up to 60 percent on strongly dissected lacustrine deposits. In some areas, slowly permeable deposits underlie the soil below 102 cm and restricts internal drainage. Mean annual air temperature ranges from 3 to 8 degrees C, mean annual precipitation ranges from 28 to 50 inches, and the frost-free period ranges from 90 to 160 days. Elevation ranges from 37 to 610 meters above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Swanville: Possible
- Adams: Weak indication
- Colton: Weak indication
- Peru: Weak indication
- Tunbridge: Weak indication
- Berkshire: Weak indication
See it on the map
Open a Nicholville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nicholville very fine sandy loam, 0 to 3 percent slopes, map unit 632A in Coos County Area, New Hampshire.
- Official Series Description: Nicholville(revised 06/2016), established.
- Taxonomic class: Coarse-silty, isotic, frigid Aquic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.