Tindahay soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tindahay shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tindahay soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tindahay spot on the map
Rated from the USDA soil survey record for Tindahay-Royal-Badland complex, 1 to 90 percent slopes (Owyhee County Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (1): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- TopsoilA1 A loamy fine sand layer about 0 to 14 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A fine sandy loam layer about 14 to 24 in down: about 13% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC1best layer A sand layer about 24 to 42 in down: about 4% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC2 A fine gravelly coarse sand layer about 42 to 60 in down: about 4% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (C1), 24 to 42 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; soft, very friable; nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium and/or eolian deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Idaho, in these survey areas: Ada County, Idaho; Owyhee County Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Extensive in the Snake River Plains of Idaho; MLRA 11..
USDA, geographic setting: Tindahay soils are on alluvial fans, fan piedmonts and extremely dissected terraces, in places modified by wind into low hummocks. Slopes are 0 to 30 percent. Elevations range from about 2,000 to 4,700 feet. The soils formed in mixed alluvium or eolian deposits. Mean annual precipitation is 8 to 12 inches, including up to 2 feet of snow. Frost-free period of 100 and 160 days and mean annual temperature is 45 to 53 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
See it on the map
Open a Tindahay spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 35%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tindahay-Royal-Badland complex, 1 to 90 percent slopes, map unit 178 in Owyhee County Area, Idaho.
- Official Series Description: Tindahay(revised 05/2000), established.
- Taxonomic class: Sandy, mixed, mesic Xeric Torriorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.