Tillery soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 10 to 58 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tillery soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tillery spot on the map
Rated from the USDA soil survey record for Tillery silt loam, 0 to 6 percent slopes, rarely flooded (Montgomery County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 29% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 48 in (122 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 16% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBtbest layer A silty clay loam layer about 10 to 58 in down: about 29% clay, moderate plasticity when wet, brownish yellow when moist. Promising
- Sandy layerCg A silt loam layer about 58 to 80 in down: about 18% clay, moderate plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 10 to 58 in down in the typical profile: brownish yellow (10YR 6/6). Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium derived from igneous and metamorphic rock.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in North Carolina, in these survey areas: Montgomery County, North Carolina; Moore County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Distribution: North Carolina and possibly South Carolina
USDA, geographic setting: Landscape: Piedmont
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Badin: Strong lead
- Herndon: Strong lead
- Iredell: Strong lead
- Lignum: Strong lead
- Nanford: Strong lead
- Tarrus: Strong lead
- Wynott: Strong lead
- Georgeville: Promising
See it on the map
Open a Tillery spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tillery silt loam, 0 to 6 percent slopes, rarely flooded, map unit TeB in Montgomery County, North Carolina.
- Official Series Description: Tillery(revised 02/2026), established.
- Taxonomic class: Fine-silty, siliceous, subactive, thermic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.