Georgeville soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 8 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Georgeville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Georgeville spot on the map
Rated from the USDA soil survey record for Georgeville gravelly silt loam, 2 to 8 percent slopes (Moore County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 44% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
- Missing data Held at "Promising" because no plasticity evidence is available; a high clay percentage alone does not make a strong lead.
Layer by layer
- TopsoilAp A gravelly silt loam layer about 0 to 8 in down: about 16% clay, low plasticity when wet, strong brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 8 to 43 in down: about 44% clay, moderate plasticity when wet, red when moist. Promising
- Loamy layerBC A silty clay loam layer about 43 to 59 in down: about 30% clay, high plasticity when wet, light red when moist. Promising
- Loamy layerC A silt loam layer about 59 to 80 in down: about 18% clay, low plasticity when wet, mottled red when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 8 to 43 in down in the typical profile: red (2.5YR 5/8); firm. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from metavolcanics and/or argillite.
- USDA family mineralogy: kaolinitic. Kaolinite-dominated clays are typically less plastic than smectitic clays.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 24 map units in North Carolina, in these survey areas: Davidson County, North Carolina; Montgomery County, North Carolina; Moore County, North Carolina; Randolph County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Alabama, Georgia, North Carolina, South Carolina, and Virginia.
USDA, geographic setting: Landscape: Piedmont Plateau of the thermic Southern Piedmont
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Badin: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Davidson: Strong lead
- Iredell: Strong lead
- Mecklenburg: Strong lead
- Pacolet: Strong lead
- Vance: Strong lead
See it on the map
Open a Georgeville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Georgeville gravelly silt loam, 2 to 8 percent slopes, map unit GeB in Moore County, North Carolina.
- Official Series Description: Georgeville(revised 09/2025), established.
- Taxonomic class: Fine, kaolinitic, thermic Typic Kanhapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.