Vance soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 10 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Vance soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Vance sandy loam, 8 to 15 percent slopes (Davidson County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (36.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 28 in (72 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A sandy loam layer about 0 to 8 in down: about 14% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerE A sandy loam layer about 8 to 10 in down: about 14% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 10 to 38 in down: about 48% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Loamy layerC1 A sandy clay loam layer about 38 to 50 in down: about 20% clay, low plasticity when wet. Weak indication
- Loamy layerC2 A loam layer about 50 to 80 in down: about 20% clay, low plasticity when wet. Weak indication
What it looks like raw
The clay subsoil (Bt), 10 to 38 in down in the typical profile: yellowish brown (10YR 5/8); very firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: saprolite derived from granite and gneiss and/or schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 11 map units in North Carolina, in these survey areas: Davidson County, North Carolina; Forsyth County, North Carolina; Guilford County, North Carolina; Randolph County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Piedmont of Virginia, North Carolina, South Carolina, Georgia, and Alabama. The series is of moderate extent.
USDA, geographic setting: Vance soils are on gently sloping narrow and broad ridges and sloping to moderately steep side slopes in the Piedmont. Slopes range from 2 to 25 percent. These soils formed in residuum weathered from felsic crystalline rock, primarily aplitic granite. Mean annual precipitation is about 44 inches and mean annual air temperature is about 6l degrees F. near the type location.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Mecklenburg: Strong lead
- Enon: Strong lead
- Nathalie: Strong lead
- Pacolet: Strong lead
- Wynott: Strong lead
- Badin: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Vance sandy loam, 8 to 15 percent slopes, map unit VaD in Davidson County, North Carolina.
- Official Series Description: Vance(revised 10/2021), established.
- Taxonomic class: Fine, mixed, semiactive, thermic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.