Mecklenburg soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 8 to 25 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Mecklenburg soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Mecklenburg spot on the map
Rated from the USDA soil survey record for Mecklenburg loam, 2 to 8 percent slopes (Davidson County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (31.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 17 in (44 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 8 in down: about 17% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 8 to 25 in down: about 50% clay, high plasticity when wet, yellowish red when moist. Strong lead
- Loamy layerBC A clay loam layer about 25 to 36 in down: about 30% clay, moderate plasticity when wet, yellowish red when moist. Promising
- Loamy layerC A sandy clay loam layer about 36 to 80 in down: about 25% clay, moderate plasticity when wet, mottled yellowish red when moist. Possible
What it looks like raw
The clay subsoil (Bt), 8 to 25 in down in the typical profile: yellowish red (5YR 4/6); firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: saprolite derived from diorite and/or gabbro and/or diabase and/or gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 17 map units in North Carolina, Virginia, in these survey areas: Davidson County, North Carolina; Forsyth County, North Carolina; Guilford County, North Carolina; Randolph County, North Carolina; Stafford and King George Counties, Virginia.
By state: wild clay in North Carolina,wild clay in Virginia.
USDA, distribution and extent: Distribution: Alabama, Georgia, North Carolina, South Carolina and Virginia. Extent: Moderate
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Vance: Strong lead
- Enon: Strong lead
- Nathalie: Strong lead
- Pacolet: Strong lead
- Wynott: Strong lead
- Badin: Strong lead
See it on the map
Open a Mecklenburg spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Mecklenburg loam, 2 to 8 percent slopes, map unit MeB in Davidson County, North Carolina.
- Official Series Description: Mecklenburg(revised 11/2025), established.
- Taxonomic class: Fine, mixed, active, thermic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.