Herndon soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 8 to 73 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Herndon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Herndon spot on the map
Rated from the USDA soil survey record for Herndon silt loam, 2 to 8 percent slopes (Montgomery County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (26.5): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 65 in (165 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 3 in down: about 14% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerE A silt loam layer about 3 to 8 in down: about 14% clay, low plasticity when wet, pale olive when moist. Weak indication
- Clay subsoilBtbest layer A silty clay layer about 8 to 73 in down: about 48% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Loamy layerC A silty clay loam layer about 73 to 80 in down: about 29% clay, high plasticity when wet, strong brown when moist. Possible
What it looks like raw
The clay subsoil (Bt), 8 to 73 in down in the typical profile: yellowish brown (10YR 5/8); friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from metavolcanics and/or argillite.
- USDA family mineralogy: kaolinitic. Kaolinite-dominated clays are typically less plastic than smectitic clays.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in North Carolina, in these survey areas: Montgomery County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Distribution: Alabama, Georgia, North Carolina, South Carolina, and Virginia. Extent: Extensive.
USDA, geographic setting: Landscape: Piedmont upland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Badin: Strong lead
- Wynott: Strong lead
- Biscoe: Promising
- Georgeville: Promising
- Shellbluff: Promising
- State: Promising
- Tillery: Promising
- Chenneby: Possible
See it on the map
Open a Herndon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Herndon silt loam, 2 to 8 percent slopes, map unit HaB in Montgomery County, North Carolina.
- Official Series Description: Herndon(revised 09/2025), established.
- Taxonomic class: Fine, kaolinitic, thermic Typic Kanhapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.