Chenneby soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 16 to 55 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Chenneby soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Chenneby spot on the map
Rated from the USDA soil survey record for Chenneby silt loam, 0 to 2 percent slopes, frequently flooded (Randolph County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 16 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerBwbest layer A silt loam layer about 16 to 55 in down: about 18% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerCg A silty clay loam layer about 55 to 80 in down: about 28% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The loamy layer (Bw), 16 to 55 in down in the typical profile: brown (10YR 4/3); friable. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium derived from igneous and metamorphic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in North Carolina, in these survey areas: Montgomery County, North Carolina; Randolph County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Alabama, Arkansas, Georgia, Mississippi, North Carolina, South Carolina, Tennessee, and Virginia. The series is of moderate extent.
USDA, geographic setting: Chenneby soils are on flood plains and depressions. Slope gradients range from 0 to 3 percent. Chenneby soils are subject to occasional or frequent flooding of very brief duration or ponding. During periods of high rainfall the water table is 1.0 foot to 2.5 feet from the surface. The soil formed in silty alluvium 3 to 6 feet thick. Near the type location, average annual rainfall is 52 inches and the average annual air temperature is 63 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Badin: Strong lead
- Wynott: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Coronaca: Strong lead
- Davidson: Strong lead
- Dorian: Strong lead
- Helena: Strong lead
See it on the map
Open a Chenneby spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Chenneby silt loam, 0 to 2 percent slopes, frequently flooded, map unit CfA in Randolph County, North Carolina.
- Official Series Description: Chenneby(revised 04/2011), established.
- Taxonomic class: Fine-silty, mixed, active, thermic Fluvaquentic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.