Helena soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 12 to 39 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Helena soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Helena sandy loam, 2 to 6 percent slopes (Randolph County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (37): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A sandy loam layer about 0 to 8 in down: about 13% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerE A sandy loam layer about 8 to 12 in down: about 13% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 12 to 39 in down: about 48% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Clay-rich layerBC A clay loam layer about 39 to 46 in down: about 36% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
- Loamy layerC A coarse sandy loam layer about 46 to 80 in down: about 18% clay, low plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 12 to 39 in down in the typical profile: yellowish brown (10YR 5/8); firm; sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: saprolite derived from granite and gneiss and/or schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Georgia, North Carolina, in these survey areas: Cherokee, Gilmer, and Pickens Counties, Georgia; Cobb County, Georgia; Douglas County, Georgia; Guilford County, North Carolina; Randolph County, North Carolina.
By state: wild clay in Georgia,wild clay in North Carolina.
USDA, distribution and extent: Distribution: Alabama, Georgia, North Carolina, South Carolina, and Virginia
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Madison: Strong lead
- Cecil: Strong lead
- Coronaca: Strong lead
- Davidson: Strong lead
- Gwinnett: Strong lead
- Hiwassee: Strong lead
- Louisa: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Helena sandy loam, 2 to 6 percent slopes, map unit HeB in Randolph County, North Carolina.
- Official Series Description: Helena(revised 02/2026), established.
- Taxonomic class: Fine, mixed, semiactive, thermic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.