Hiwassee soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 7 to 61 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hiwassee soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hiwassee spot on the map
Rated from the USDA soil survey record for Hiwassee loam, 2 to 6 percent slopes (Cobb County, Georgia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (24): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 54 in (137 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- Loamy layerH1 A loam layer about 0 to 7 in down: about 23% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
- Clay-rich layerH2best layer A clay layer about 7 to 61 in down: about 48% clay, high plasticity when wet, dark red when moist. Strong lead
- Loamy layerH3 A sandy clay loam layer about 61 to 70 in down: about 21% clay, moderate plasticity when wet, red when moist. Weak indication
What it looks like raw
The clay-rich layer (H2), 7 to 61 in down in the typical profile: dark red (2.5YR 3/6); firm; moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from amphibolite and/or residuum weathered from gneiss.
- USDA family mineralogy: kaolinitic. Kaolinite-dominated clays are typically less plastic than smectitic clays.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 11 map units in Georgia, North Carolina, in these survey areas: Cherokee, Gilmer, and Pickens Counties, Georgia; Cobb County, Georgia; DeKalb County, Georgia; Forsyth County, North Carolina; Fulton County, Georgia.
By state: wild clay in Georgia,wild clay in North Carolina.
USDA, distribution and extent: Alabama, Georgia, Virginia, North Carolina, and South Carolina. The series is of small to moderate extent.
USDA, geographic setting: Hiwassee soils are on nearly level to moderately sloping high terraces in the Southern Piedmont. Slopes range from 0 to 25 percent. The soil formed in old alluvium from felsic and mafic rock, and is underlain with felsic or mafic residuum in some pedons. Mean annual air temperature ranges from 57 to 61 degrees F. Mean annual precipitation ranges from 35 to 45 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Madison: Strong lead
- Cecil: Strong lead
- Pacolet: Strong lead
- Gwinnett: Strong lead
- Enon: Strong lead
- Helena: Strong lead
- Wedowee: Strong lead
See it on the map
Open a Hiwassee spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hiwassee loam, 2 to 6 percent slopes, map unit HSB in Cobb County, Georgia.
- Official Series Description: Hiwassee(revised 08/2008), established.
- Taxonomic class: Fine, kaolinitic, thermic Rhodic Kanhapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.