Louisa soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 3 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Louisa soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Louisa fine sandy loam, 10 to 15 percent slopes (Douglas County, Georgia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts within about 3 in (8 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 3 in down: about 14% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay-rich layerH2best layer A clay layer about 3 to 29 in down: about 50% clay, high plasticity when wet, weathered olive gray when moist. Strong lead
- Loamy layerH3 A sandy clay loam layer about 29 to 52 in down: about 23% clay, moderate plasticity when wet, weathered olive gray when moist. Possible
- Sandy layerH4 A loam layer about 52 to 70 in down: about 18% clay, low plasticity when wet, weathered olive gray when moist. Weak indication
What it looks like raw
The clay-rich layer (H2), 3 to 29 in down in the typical profile: weathered olive gray (5Y 4/2). Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from mica schist and/or residuum weathered from gneiss.
- USDA family mineralogy: kaolinitic. Kaolinite-dominated clays are typically less plastic than smectitic clays.
- USDA family particle-size class: clayey.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Georgia, in these survey areas: Cobb County, Georgia; Douglas County, Georgia.
By state: wild clay in Georgia.
USDA, distribution and extent: Alabama, Georgia, South Carolina, North Carolina; and Virginia. The series is moderately extensive.
USDA, geographic setting: Louisa soils are on ridges and sideslopes in highly dissected areas of the Piedmont Plateau. Slope gradients are 6 to 80 percent. Elevation is 800 to 1200 feet. Louisa soils formed in residuum weathered from micaceous gneiss and schist rocks. The climate is warm and humid. The average annual temperature ranges from about 60 to 65 degrees F., average annual precipitation ranges from about 45 to 55 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Helena: Strong lead
- Madison: Strong lead
- Cecil: Strong lead
- Davidson: Strong lead
- Gwinnett: Strong lead
- Hiwassee: Strong lead
- Lloyd: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Louisa fine sandy loam, 10 to 15 percent slopes, map unit LjD in Douglas County, Georgia.
- Official Series Description: Louisa(revised 10/2021), established.
- Taxonomic class: Loamy, micaceous, thermic, shallow Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.