Swedesboro soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 30 to 40 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Swedesboro soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Swedesboro spot on the map
Rated from the USDA soil survey record for Swedesboro loamy sand, 0 to 5 percent slopes (Salem County, New Jersey) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt3" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (12).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilAp A loamy sand layer about 0 to 10 in down: about 6% clay, low plasticity when wet, olive brown when moist. Weak indication
- Sandy layerBA A loamy sand layer about 10 to 14 in down: about 9% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Clay subsoilBt1 A sandy loam layer about 14 to 26 in down: about 18% clay, moderate plasticity when wet, olive yellow when moist. Weak indication
- Clay subsoilBt2 A sandy clay loam layer about 26 to 30 in down: about 23% clay, moderate plasticity when wet, olive yellow when moist. Weak indication
- Clay subsoilBt3best layer A fine sandy loam layer about 30 to 40 in down: about 18% clay, moderate plasticity when wet, brownish yellow when moist. Possible
- Sandy layerBC A loamy fine sand layer about 40 to 46 in down: about 6% clay, low plasticity when wet, olive yellow when moist. Weak indication
- Sandy layer2C1 A sand layer about 46 to 54 in down: about 3% clay, low plasticity when wet, olive yellow when moist. Weak indication
- Sandy layer2C2 A sand layer about 54 to 72 in down: about 3% clay, low plasticity when wet, olive yellow when moist. Weak indication
What it looks like raw
The clay subsoil (Bt3), 30 to 40 in down in the typical profile: brownish yellow (10YR 6/6); fine sandy loam; friable; slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: glauconitic sandy marine deposits and/or glauconitic loamy marine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maryland, New Jersey, in these survey areas: Prince George's County, Maryland; Salem County, New Jersey.
By state: wild clay in Maryland,wild clay in New Jersey.
USDA, geographic setting: Landscape: Coastal Plain uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Howell: Strong lead
- Lenni: Strong lead
- Magnolia: Strong lead
- Aquasco: Promising
- Chillum: Promising
- Dodon: Promising
- Elkton: Promising
See it on the map
Open a Swedesboro spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Swedesboro loamy sand, 0 to 5 percent slopes, map unit SwtB in Salem County, New Jersey.
- Official Series Description: Swedesboro(revised 11/2002), established.
- Taxonomic class: Coarse-loamy, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.