Shrewsbury soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 9 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Shrewsbury soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Shrewsbury spot on the map
Rated from the USDA soil survey record for Shrewsbury loam, 0 to 2 percent slopes (Prince George's County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 33% clay in the fine-earth portion.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 7 in down: about 20% clay, low plasticity when wet, dark gray when moist. Weak indication
- Loamy layerBEg A loam layer about 7 to 9 in down: about 19% clay, low plasticity when wet, dark gray when moist. Weak indication
- Clay subsoilBtgbest layer A sandy clay loam layer about 9 to 28 in down: about 33% clay, moderate plasticity when wet, mixed gray when moist. Promising
- Loamy layerBCg A sandy clay loam layer about 28 to 82 in down: about 25% clay, moderate plasticity when wet, alternating strata of olive gray when moist. Possible
What it looks like raw
The clay subsoil (Btg), 9 to 28 in down in the typical profile: mixed gray (5Y 5/1), light olive gray (5Y 6/2), greenish gray (5GY 5/1), and dark gray (10YR 4/1); friable, slightly sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: glauconite bearing loamy fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Maryland, in these survey areas: Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, geographic setting: Landscape: Atlantic Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Howell: Strong lead
- Lenni: Strong lead
- Magnolia: Strong lead
- Aquasco: Promising
- Chillum: Promising
- Dodon: Promising
- Elkton: Promising
See it on the map
Open a Shrewsbury spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Shrewsbury loam, 0 to 2 percent slopes, map unit SrA in Prince George's County, Maryland.
- Official Series Description: Shrewsbury(revised 11/2002), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Endoaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.