Shimo soil
Wild-clay potential
Weak indication
Weak indication: no layer of Shimo shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Shimo soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Shimo-Kisky-Schiller complex, 35 to 90 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 13 in (34 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Lowers the potential High rock content (about 55% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA1 A fine gravelly loamy sand layer about 0 to 3 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
- TopsoilA2 A fine gravelly loamy sand layer about 3 to 12 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerCbest layer A very gravelly loamy sand layer about 12 to 25 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
- BedrockR Bedrock about 25 to 35 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (C), 12 to 25 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from granodiorite over residuum weathered from granodiorite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: excessively drained.
- Lithic bedrock typically about 25 in (64 cm) down.
Where it is mapped
Seen on the map as the most common soil in 9 map units in Idaho, in these survey areas: Ada County, Idaho; Boise County Area, Idaho, Western Part; South Idaho Forests, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 10. Shimo soils are moderately extensive.
USDA, geographic setting: Shimo soils are on hill back slopes and canyon walls at elevations of 2,500 to 6,300 feet, occurring only on south aspects at higher elevations. These soils formed in colluvium from granitic rocks and rhyolite. Slopes range from 25 to 90 percent. The average annual precipitation is 13 to 22 inches. The average annual temperature is 45 to 51 degrees F. The frost-free period is 90 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aradaran: Strong lead
- Hann: Strong lead
- McDesh: Strong lead
- Shafer: Strong lead
- Aldape: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Shimo-Kisky-Schiller complex, 35 to 90 percent slopes, map unit 5034 in Ada County, Idaho.
- Official Series Description: Shimo(revised 06/2006), established.
- Taxonomic class: Sandy-skeletal, mixed, mesic Entic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.