Scism soil
Wild-clay potential
Weak indication
Weak indication: no layer of Scism shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Scism soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Scism silt loam, 0 to 1 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 8% by volume).
- Note USDA reports about 18% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 8 in down: about 15% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBk A silt loam layer about 8 to 21 in down: about 11% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerBkq A cemented silt loam layer about 21 to 30 in down: about 15% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerCbest layer A loam layer about 30 to 62 in down: about 15% clay, moderate plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 30 to 62 in down in the typical profile: pale brown (10YR 6/3), dark grayish brown (10YR 4/2) moist. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and/or mixed alluvium and/or loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 17 map units in Idaho, in these survey areas: Ada County, Idaho; Canyon Area, Idaho; Owyhee County Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho; MLRA 11. This series is moderately extensive.
USDA, geographic setting: Scism soils are on lava plains, shield volcanoes, calderas, terraces, draws, and tablelands at elevations of 2,000 to 5,000 feet. Slopes range from 0 to 20 percent, but most commonly are less than 8 percent. These soils formed in loess and weathered volcanic ash over loamy alluvium from lacustrine deposits, volcanic ash and basalt. Average annual precipitation is 8 to 11 inches, including up to 25 inches of snow. Average annual temperature is 45 to 54 degrees F. Frost-free period is 100 to 160 days. - terms used throughout MLRA 11 to identify the setting of this soil are quite varied although all equate to the same landscape. There will be further investigation from an MLRA project level...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Scism silt loam, 0 to 1 percent slopes, map unit ScA in Canyon Area, Idaho.
- Official Series Description: Scism(revised 08/2000), established.
- Taxonomic class: Coarse-silty, mixed, superactive, mesic Xereptic Haplodurids
- Rated with rule version 2026-09-28.1; the method is on the About page.