Roseberry soil
Wild-clay potential
Weak indication
Weak indication: no layer of Roseberry shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Roseberry soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Roseberry spot on the map
Rated from the USDA soil survey record for Roseberry loam, 0 to 2 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Note Moderate engineering plasticity index (7).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
- Lowers the potential Surface layer with about 4.5% organic matter; roots and organics complicate use.
Layer by layer
- TopsoilAbest layer A loam layer about 0 to 18 in down: about 12% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- Sandy layerC1 A loam layer about 18 to 26 in down: about 12% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC2 A loamy sand layer about 26 to 40 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC3 A sandy loam layer about 40 to 55 in down: about 12% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC4 A gravelly sand layer about 55 to 60 in down: about 4% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The topsoil (A), 0 to 18 in down in the typical profile: dark gray (10YR 4/1), very dark gray (2.5Y 3/1) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: outwash derived from granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: poorly drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Distribution is in high mountain valleys; mainly in Valley County, Idaho. The soil is inextensive.
USDA, geographic setting: Roseberry soils are on outwash plains and stream terraces. Slopes are 0 to 3 percent. The soils formed in coarse textured granitic glacial outwash. Elevations are 3,800 to 5,000 feet. Average annual precipitation is 22 to 24 inches. Average January temperature is 20 degrees F.; mean July temperature is 64 degrees F. Average annual temperature is 38 degrees to 43 degrees F. Frost-free season is about 60 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Culdecole: Promising
- Nisula: Promising
- Archabal: Possible
- Tica: Possible
See it on the map
Open a Roseberry spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Roseberry loam, 0 to 2 percent slopes, map unit 186 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Roseberry, established.
- Taxonomic class: Sandy, mixed Humic Cryaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.