Reaville soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 8 to 19 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Reaville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Reaville spot on the map
Rated from the USDA soil survey record for Reaville silt loam, 0 to 3 percent slopes (Berks County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (19).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 27% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 8 in down: about 19% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Clay subsoilBtbest layer A channery silty clay loam layer about 8 to 19 in down: about 28% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Loamy layerC A very channery silt loam layer about 19 to 32 in down: about 24% clay, moderate plasticity when wet, dusky red when moist. Weak indication
- BedrockR Bedrock about 32 to 42 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 8 to 19 in down in the typical profile: reddish brown (2.5YR 4/4); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: red Triassic residuum weathered from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 32 in (81 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Pennsylvania, New Jersey, Maryland, and Virginia. The series is of moderate extent.
USDA, geographic setting: Reaville soils are on interfluves with very little dissection. Slope ranges from 0 to 15 percent. The soil formed in residuum weathered from red interbedded, Triassic shale, siltstone, and fine- grained sandstone. The climate is humid and temperate; mean annual precipitation ranges from 40 to 46 inches, mean annual temperature ranges from 50 to 60 degrees F., and the growing season ranges from 150 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Bowmansville: Promising
- Croton: Promising
- Mount Lucas: Promising
- Raritan: Promising
- Readington: Promising
- Rowland: Promising
See it on the map
Open a Reaville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Reaville silt loam, 0 to 3 percent slopes, map unit RhA in Berks County, Pennsylvania.
- Official Series Description: Reaville(revised 02/2008), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Aquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.