Readington soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 17 to 34 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Readington soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Readington spot on the map
Rated from the USDA soil survey record for Readington silt loam, 3 to 8 percent slopes (Lebanon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (19).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 18% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1 A silt loam layer about 10 to 17 in down: about 26% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Clay subsoilBt2best layer A silty clay loam layer about 17 to 34 in down: about 28% clay, moderate plasticity when wet, yellowish red when moist. Promising
- Clay subsoilBtx A clay loam layer about 34 to 48 in down: about 30% clay, high plasticity when wet, percent yellowish red when moist. Promising
- Loamy layerC A channery silt loam layer about 48 to 58 in down: about 25% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- BedrockR Bedrock about 58 to 68 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt2), 17 to 34 in down in the typical profile: yellowish red (5YR 4/6); silty clay loam; very firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: Triassic colluvium derived from shale and siltstone and/or Triassic residuum weathered from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 58 in (147 cm) down.
Where it is mapped
Seen on the map as the most common soil in 15 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Chester County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Piedmont of southeastern Pennsylvania, Central New Jersey, Maryland, and Virginia. The series is of large extent.
USDA, geographic setting: Readington soils are on concave, nearly level to sloping lower hillsides, upland flats, drainage ways, and stream heads. Slopes are 0 to 15 percent. The soils formed in medium textured residuum largely from reddish noncalcareous shale, siltstone, and fine grained sandstone. The climate in humid temperature; mean annual precipitation ranges from 38 to 48 inches, mean annual air temperature ranges from 50 to 55 degrees F., and the freeze-free season ranges from 170 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Hagerstown: Strong lead
- Bowmansville: Promising
- Mount Lucas: Promising
- Duffield: Promising
- Rowland: Promising
- Towhee: Promising
- Croton: Promising
See it on the map
Open a Readington spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Readington silt loam, 3 to 8 percent slopes, map unit ReB in Lebanon County, Pennsylvania.
- Official Series Description: Readington(revised 09/2008), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Oxyaquic Fragiudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.