Croton soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 19 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Croton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Croton silt loam, occasionally ponded, 0 to 3 percent slopes (Montgomery County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Note USDA labels this a "Btxg" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (24): USDA's estimate suggests plastic behavior when wet.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 15% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 11 in down: about 25% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Clay subsoilBtg A silty clay loam layer about 11 to 19 in down: about 29% clay, high plasticity when wet, gray when moist. Promising
- Clay subsoilBtxgbest layer A channery silty clay loam layer about 19 to 30 in down: about 35% clay, high plasticity when wet, strong brown when moist. Promising
- Loamy layerCx A channery silt loam layer about 30 to 44 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockR Bedrock about 44 to 64 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Btxg), 19 to 30 in down in the typical profile: strong brown (7.5YR 5/6); silty clay loam; brittle, very firm. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Lithic bedrock typically about 44 in (112 cm) down.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 12 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Chester County, Pennsylvania; Lehigh County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: In the Triassic shale and sandstone belt in New Jersey, Pennsylvania and Maryland. The series is extensive, more than 100,000 acres.
USDA, geographic setting: Croton soils are on nearly level and sloping upland flats or in depressions. Slopes are 0 to 8 percent. The soils formed mostly in residuum weathered from fine-grained silty sandstones, argillites siltstones or red shales, but the upper soil horizons of some pedons formed in a thin silt layer deposited by either wind or water. The climate is humid temperate. Average annual precipitation ranges from 40 to 48 inches, average annual air temperature from 50 to 55 degrees F. and average frost-free season from 160 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Hagerstown: Strong lead
- Bowmansville: Promising
- Mount Lucas: Promising
- Readington: Promising
- Towhee: Promising
- Duffield: Promising
- Raritan: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Croton silt loam, occasionally ponded, 0 to 3 percent slopes, map unit CrA in Montgomery County, Pennsylvania.
- Official Series Description: Croton(revised 04/2018), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Typic Fragiaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.