Pone soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pone shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pone soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Pone mucky loam (Harford County, Aberdeen Proving Ground, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (9).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 33 in (84 cm)).
- Note Typically starts about 47 in (119 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 3 in down, not a clay body. Weak indication
- TopsoilA A mucky sandy loam layer about 3 to 14 in down: about 10% clay, low plasticity when wet, black when moist. Weak indication
- Clay subsoilBtg A sandy loam layer about 14 to 26 in down: about 16% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBCg A loamy sand layer about 26 to 37 in down: about 7% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerCg1 A sand layer about 37 to 47 in down: about 2% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layer2Cg2best layer A silt loam layer about 47 to 80 in down: about 15% clay, moderate plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (2Cg2), 47 to 80 in down in the typical profile: gray (5Y 6/1); silt loam; friable, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: siliceous.
- USDA family particle-size class: coarse-loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Maryland, in these survey areas: Harford County, Aberdeen Proving Ground, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Coastal Plain of Maryland, Delaware, and New Jersey. The series is of moderate extent.
USDA, geographic setting: Pone soils are on level or nearly level uplands and narrow floodplains, and slightly concave closed depressions of the mid-Atlantic Coastal Plain. They formed in woody organic deposits overlying unconsolidated, stratified alluvial and marine sediments. Mean annual temperature ranges from 52 to 58 degrees F., and mean annual precipitation ranges from 42 to 48 inches. Elevation at the type location is about 32 feet.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Elkton: Promising
- Kentuck: Promising
- Lenape: Promising
- Beltsville: Possible
- Codorus: Possible
- Corsica: Possible
- Fallsington: Possible
- Hambrook: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pone mucky loam, map unit Po in Harford County, Aberdeen Proving Ground, Maryland.
- Official Series Description: Pone(revised 11/2002), established.
- Taxonomic class: Coarse-loamy, siliceous, active, mesic Typic Umbraquults
- Rated with rule version 2026-09-28.1; the method is on the About page.