Lenape soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 26 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lenape soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Lenape mucky peat (Harford County, Aberdeen Proving Ground, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (10).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Organic top layerOe An organic top layer about 0 to 8 in down, not a clay body. Weak indication
- Organic top layerOa An organic top layer about 8 to 26 in down, not a clay body. Weak indication
- Loamy layerH3best layer A silty clay loam layer about 26 to 60 in down: about 30% clay, moderate plasticity when wet, dark greenish gray when moist. Promising
- Sandy layerH4 A sand layer about 60 to 72 in down: about 5% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The loamy layer (H3), 26 to 60 in down in the typical profile: dark greenish gray (5GY 4/1); firm, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Delaware, Maryland, in these survey areas: Cecil County, Maryland; Harford County, Aberdeen Proving Ground, Maryland; New Castle County, Delaware.
By state: wild clay in Delaware,wild clay in Maryland.
USDA, distribution and extent: Distribution: Maryland and Delaware
USDA, geographic setting: Landscape: Coastal plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Watchung: Strong lead
- Christiana: Strong lead
- Lenni: Strong lead
- Talleyville: Strong lead
- Baile: Promising
- Delanco: Promising
- Elkton: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lenape mucky peat, map unit Le in Harford County, Aberdeen Proving Ground, Maryland.
- Official Series Description: Lenape(revised 12/2012), established.
- Taxonomic class: Loamy, mixed, dysic, mesic Terric Haplosaprists
- Rated with rule version 2026-09-28.1; the method is on the About page.