Philo soil
Wild-clay potential
Weak indication
Weak indication: no layer of Philo shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Philo soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Philo silt loam (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (5.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 44 in (112 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 12 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw1 A silt loam layer about 12 to 19 in down: about 12% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerBw2 A very fine sandy loam layer about 19 to 31 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBC A very fine sandy loam layer about 31 to 39 in down: about 10% clay, low plasticity when wet, variegated gray when moist. Weak indication
- Sandy layerC A silt loam layer about 39 to 44 in down: about 12% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layer2Cbest layer A stratified very gravelly loamy sand layer about 44 to 72 in down: about 5% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (2C), 44 to 72 in down in the typical profile: gray (10YR 5/1); friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium over stratified sand and gravel.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 9 map units in New York, Pennsylvania, in these survey areas: Centre County, Pennsylvania; Delaware County, New York; Huntingdon County, Pennsylvania; Lebanon County, Pennsylvania; Schuylkill County, Pennsylvania; Venango County, Pennsylvania; Warren and Forest Counties, Pennsylvania.
By state: wild clay in New York,wild clay in Pennsylvania.
USDA, distribution and extent: Southern Indiana, Kentucky, Maryland, New York, Southern Ohio, Pennsylvania, Tennessee, Virginia, and West Virginia. MLRA Extent is large.
USDA, geographic setting: Philo soils are on nearly level flood plains. Slopes range from 0 to 5 percent, but are dominantly 0 to 3 percent. The soils developed in recent alluvium washed mainly from sandstone and shale derived soils. Climate is humid temperate. Average annual precipitation ranges from 950 to 1400 millimeters and mean annual air temperature ranges from 8 to 14 degrees C. The number of days without killing frost ranges from 140 to 210.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cavode: Strong lead
- Hagerstown: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Armagh: Strong lead
- Dunning: Strong lead
- Edom: Strong lead
- Millheim: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Philo silt loam, map unit Pc in Delaware County, New York.
- Official Series Description: Philo(revised 04/2025), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Fluvaquentic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.