Peacham soil
Wild-clay potential
Weak indication
Weak indication: no layer of Peacham shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Peacham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Peacham spot on the map
Rated from the USDA soil survey record for Peacham mucky peat, 0 to 8 percent slopes, very stony (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 31 in (79 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOe An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Organic top layerOa An organic top layer about 2 to 10 in down, not a clay body. Weak indication
- Sandy layerBg A fine sandy loam layer about 10 to 15 in down: about 4% clay, low plasticity when wet, dark greenish gray when moist. Weak indication
- Sandy layerCdg1 A fine sandy loam layer about 15 to 31 in down: about 6% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerCdg2best layer A sandy loam layer about 31 to 65 in down: about 6% clay, low plasticity when wet, dark olive gray when moist. Weak indication
What it looks like raw
The sandy layer (Cdg2), 31 to 65 in down in the typical profile: dark olive gray (5Y 3/2); sandy loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: organic material over loamy lodgment till derived from schist and/or loamy lodgment till derived from granite and gneiss and/or loamy lodgment till derived from phyllite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 4 map units in New Hampshire, Vermont, in these survey areas: Chittenden County, Vermont; Coos County Area, New Hampshire; Washington County, Vermont.
By state: wild clay in New Hampshire,wild clay in Vermont.
USDA, distribution and extent: Vermont, Maine, Massachusetts, and New Hampshire; MLRAs 143 and 144B. These soils are extensive with about 160,000 acres of the series mapped.
USDA, geographic setting: Peacham soils are on nearly level to gently sloping areas in glaciated uplands and lowlands. They are typically in open and closed depressions on footslopes and toeslopes. The soils formed in organic material 20 to 40 cm thick and the underlying loamy lodgment till. The till is Wisconsin-aged and derived mainly from granite, gneiss, schist, and phyllite. Slope ranges from 0 to 8 percent. The mean annual precipitation is 790 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost-free period ranges from 70 to 135 days. Elevation ranges from about 100 to 800 meters above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Adams: Weak indication
- Colton: Weak indication
- Peru: Weak indication
- Berkshire: Weak indication
- Cabot: Weak indication
- Grange: Weak indication
See it on the map
Open a Peacham spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 78%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Peacham mucky peat, 0 to 8 percent slopes, very stony, map unit 549A in Coos County Area, New Hampshire.
- Official Series Description: Peacham(revised 05/2015), established.
- Taxonomic class: Loamy, mixed, superactive, nonacid, frigid, shallow Histic Humaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.