Cabot soil
Wild-clay potential
Weak indication
Weak indication: no layer of Cabot shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cabot soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Cabot silt loam, 0 to 8 percent slopes (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (3): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 52 in (132 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 12% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 9% clay, low plasticity when wet, very dark gray when moist. Weak indication
- Sandy layerBg A fine sandy loam layer about 7 to 13 in down: about 6% clay, low plasticity when wet, dark olive gray when moist. Weak indication
- Sandy layerCdgbest layer A fine sandy loam layer about 13 to 65 in down: about 7% clay, low plasticity when wet, dark olive gray when moist. Weak indication
What it looks like raw
The sandy layer (Cdg), 13 to 65 in down in the typical profile: dark olive gray (5Y 3/2); firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy lodgment till derived from mica schist and/or loamy lodgment till derived from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 9 map units in Vermont, in these survey areas: Addison County, Vermont; Chittenden County, Vermont; Washington County, Vermont.
By state: wild clay in Vermont.
USDA, distribution and extent: Vermont, New Hampshire, and Maine; MLRAs 142, 143, and 144B. The series is extensive.
USDA, geographic setting: Cabot soils are on nearly level to moderately steep slopes on hills and mountains. They are on concave backslopes and footslopes, on toeslopes, and in depressions and drainageways. Less frequently, Cabot soils occur on broad till plains. The soils formed in loamy lodgment till of Wisconsin age derived mainly from schistose rocks and impure limestone. Slope ranges from 0 to 25 percent. Tree-tip pit and mound topography is common in unplowed areas. The mean annual precipitation is 790 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost free period is 70 to 135 days. Elevation ranges from about 100 to 650 meters above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Covington: Strong lead
- Lamoine: Strong lead
- Livingston: Strong lead
- Melrose: Strong lead
- Swanton: Strong lead
- Vergennes: Strong lead
- Elmwood: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 83%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cabot silt loam, 0 to 8 percent slopes, map unit CaB in Addison County, Vermont.
- Official Series Description: Cabot(revised 07/2025), established.
- Taxonomic class: Loamy, mixed, active, nonacid, frigid, shallow Typic Humaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.