Parchin soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 19 to 32 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Parchin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Parchin spot on the map
Rated from the USDA soil survey record for Parchin-Bullock fine sandy loams, 2 to 6 percent slopes (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 6 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A fine sandy loam layer about 6 to 12 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
- Loamy layerH3 A sandy clay loam layer about 12 to 19 in down: about 26% clay, high plasticity when wet, grayish brown when moist. Possible
- Loamy layerH4best layer A sandy clay loam layer about 19 to 32 in down: about 23% clay, high plasticity when wet, light olive gray when moist. Possible
- BedrockCr Weathered bedrock about 32 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H4), 19 to 32 in down in the typical profile: light olive gray (5Y 6/2), olive gray (5Y 4/2) moist; hard, friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (77 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Eastern Montana, western South Dakota, and possibly in adjacent areas of North Dakota and Wyoming. The series is of moderate extent.
USDA, geographic setting: The Parchin soils are on nearly level to moderately steep uplands and have plane or concave slopes. The slope gradients range from 0 to 25 percent slopes. The soils formed in sandy and loamy residuum weathered from sandy and loamy sedimentary rocks. Mean annual air temperature is 39 to 45 degrees F, and mean annual precipitation is 10 to 18 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
See it on the map
Open a Parchin spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Parchin-Bullock fine sandy loams, 2 to 6 percent slopes, map unit PbB in Meade County, South Dakota, Northern Part.
- Official Series Description: Parchin, established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Aridic Natrustalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.