Othello soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 9 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Othello soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Othello spot on the map
Rated from the USDA soil survey record for Othello silt loams, 0 to 2 percent slopes, Northern Coastal Plain (Harford County, Aberdeen Proving Ground, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (14).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 20 in (51 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 9 in down: about 13% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- Clay subsoilBtgbest layer A silt loam layer about 9 to 29 in down: about 24% clay, moderate plasticity when wet, gray when moist. Possible
- Sandy layer2BCg A sandy loam layer about 29 to 34 in down: about 11% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layer2Cg A loamy sand layer about 34 to 80 in down: about 7% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The clay subsoil (Btg), 9 to 29 in down in the typical profile: gray (10YR 6/1); firm; moderately sticky; moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty eolian deposits over fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 9 map units in Delaware, Maryland, New Jersey, Pennsylvania, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; Delaware County, Pennsylvania; Harford County Area, Maryland; Harford County, Aberdeen Proving Ground, Maryland; New Castle County, Delaware; Salem County, New Jersey.
By state: wild clay in Delaware,wild clay in Maryland,wild clay in New Jersey,wild clay in Pennsylvania.
USDA, distribution and extent: Distribution: Coastal Plain of Delaware, New Jersey, and Maryland
USDA, geographic setting: Landscape: Lowland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Watchung: Strong lead
- Christiana: Strong lead
- Talleyville: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
See it on the map
Open a Othello spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Othello silt loams, 0 to 2 percent slopes, Northern Coastal Plain, map unit Ot in Harford County, Aberdeen Proving Ground, Maryland.
- Official Series Description: Othello(revised 01/2010), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Typic Endoaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.