Otero soil
Wild-clay potential
Weak indication
Weak indication: no layer of Otero shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Otero soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Otero sandy loam, 0 to 1 percent slopes (Weld County, Colorado, Southern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 48 in (122 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 12 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2best layer A fine sandy loam layer about 12 to 60 in down: about 15% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 12 to 60 in down in the typical profile: very pale brown (10YR 7/3), brown (10YR 5/3) moist; slightly hard, very friable. Raw colour is not fired colour.
About the soil
- Parent material: eolian deposits and/or mixed outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Colorado, in these survey areas: Weld County, Colorado, Southern Part.
By state: wild clay in Colorado.
USDA, distribution and extent: Eastern Colorado, western Nebraska, and southeastern Wyoming. LRR G, MLRA 67; The series is of large extent.
USDA, geographic setting: Landscape: hills, and alluvial plains
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Heldt: Strong lead
- Midway: Strong lead
- Nunn: Strong lead
- Renohill: Strong lead
- Ulm: Strong lead
- Weld: Strong lead
- Colby: Promising
- Colombo: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Otero sandy loam, 0 to 1 percent slopes, map unit 50 in Weld County, Colorado, Southern Part.
- Official Series Description: Otero(revised 02/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, calcareous, mesic Aridic Ustorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.