Midway soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 0 to 7 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Midway soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Midway-Shingle complex, 5 to 20 percent slopes (Weld County, Colorado, Southern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (27.5): USDA's estimate suggests plastic behavior when wet.
- Note Moderate thickness (about 7 in (18 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerH1best layer A clay layer about 0 to 7 in down: about 50% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
- Clay-rich layerH2 A clay layer about 7 to 13 in down: about 40% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
- BedrockH3 Weathered bedrock about 13 to 17 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H1), 0 to 7 in down in the typical profile: light yellowish brown (2.5Y 6/4), light olive brown (2.5Y 5/4) moist; hard, firm. Raw colour is not fired colour.
About the soil
- Parent material: calcareous residuum weathered from shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey.
- Drainage: well drained.
- Paralithic bedrock typically about 13 in (33 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Colorado, in these survey areas: Weld County, Colorado, Southern Part.
By state: wild clay in Colorado.
USDA, distribution and extent: Colorado, Wyoming, Montana, South Dakota, North Dakota, Kansas. LRR E, G, and H; MLRA 49, 67, 69, 72. The series is of moderate extent.
USDA, geographic setting: Landform: crests of ridges, mesas, plains and hills in shale bedrock uplands.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Heldt: Strong lead
- Nunn: Strong lead
- Renohill: Strong lead
- Ulm: Strong lead
- Weld: Strong lead
- Colby: Promising
- Colombo: Promising
- Wiley: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Midway-Shingle complex, 5 to 20 percent slopes, map unit 36 in Weld County, Colorado, Southern Part.
- Official Series Description: Midway(revised 04/2004), established.
- Taxonomic class: Clayey, smectitic, calcareous, mesic, shallow Ustic Torriorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.