Ulm soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 13 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ulm soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ulm loam, 1 to 3 percent slopes (Adams County Area, Parts of Adams and Denver Counties, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 7 in down: about 24% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Clay-rich layerH2 A silty clay layer about 7 to 13 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerH3best layer A clay layer about 13 to 30 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Loamy layerH4 A clay loam layer about 30 to 48 in down: about 34% clay, moderate plasticity when wet, pale brown when moist. Promising
- BedrockH5 Unweathered bedrock about 48 to 52 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H3), 13 to 30 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone and shale.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 48 in (122 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Colorado, in these survey areas: Adams County Area, Parts of Adams and Denver Counties, Colorado; Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties; Weld County, Colorado, Southern Part.
By state: wild clay in Colorado.
USDA, distribution and extent: Eastern and central Wyoming, Montana and Colorado. This soil is extensive.
USDA, geographic setting: Ulm soils are on relict alluvial terraces, alluvial fans, fan remnants, plateaus and footslopes and toeslopes of hills. Slopes are 0 to 18 percent. The soils formed in fine and medium textured alluvium derived from interbedded shales and agrillaceous sandstone. Elevations are 3,500 to 6,500 feet. The mean annual precipitation is 10 to 14 inches with over half of the annual precipitation falling in April, May, and June and less than one inch falling in each month of July, August, September, and October. The mean annual air temperature ranges from 46 to 51 degrees F. The frost-free season is 105 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Nunn: Strong lead
- Platner: Strong lead
- Renohill: Strong lead
- Samsil: Strong lead
- Arvada: Strong lead
- Denver: Strong lead
- Englewood: Strong lead
- Heldt: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ulm loam, 1 to 3 percent slopes, map unit UlB in Adams County Area, Parts of Adams and Denver Counties, Colorado.
- Official Series Description: Ulm(revised 12/2005), established.
- Taxonomic class: Fine, smectitic, mesic Ustic Haplargids
- Rated with rule version 2026-09-28.1; the method is on the About page.