Samsil soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 4 to 14 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Samsil soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Samsil-Shingle complex, 3 to 35 percent slopes (Adams County Area, Parts of Adams and Denver Counties, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 58% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (32.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerH1 A clay layer about 0 to 4 in down: about 50% clay, high plasticity when wet, light brownish gray when moist. Promising
- Clay-rich layerH2best layer A silty clay layer about 4 to 14 in down: about 58% clay, high plasticity when wet, light brownish gray when moist. Strong lead
- BedrockH3 Weathered bedrock about 14 to 18 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 4 to 14 in down in the typical profile: light brownish gray (2.5Y 6/2), dark grayish brown (2.5Y 4/2), crushing to grayish brown (2.5Y 5/2) moist; hard, friable, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from shale.
- USDA family particle-size class: clayey.
- Drainage: well drained.
- Paralithic bedrock typically about 14 in (36 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Colorado, in these survey areas: Adams County Area, Parts of Adams and Denver Counties, Colorado; Boulder County Area, Colorado; Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
By state: wild clay in Colorado.
USDA, distribution and extent: Southwestern South Dakota and parts of Nebraska and Wyoming. The soil is extensive.
USDA, geographic setting: Samsil soils are on gently sloping to very steep hills, ridges and breaks of dissected shale plains. Surfaces mainly are convex, and slope gradients range from 2 to 60 percent or more. The soil formed in alluvium or residuum weathered from shale. Mean annual air temperature ranges from 45 to 48 degrees F, and mean annual precipitation ranges from 14 to 19 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Nunn: Strong lead
- Denver: Strong lead
- Englewood: Strong lead
- Platner: Strong lead
- Renohill: Strong lead
- Ulm: Strong lead
- Valmont: Strong lead
- Arvada: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Samsil-Shingle complex, 3 to 35 percent slopes, map unit ShF in Adams County Area, Parts of Adams and Denver Counties, Colorado.
- Official Series Description: Samsil(revised 06/2002), established.
- Taxonomic class: Clayey, smectitic, calcareous, mesic, shallow Aridic Ustorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.