Platner soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 11 to 20 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Platner soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Platner spot on the map
Rated from the USDA soil survey record for Platner loam, 0 to 3 percent slopes (Adams County Area, Parts of Adams and Denver Counties, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 40% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (29): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 9 in (23 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.3%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A loam layer about 0 to 6 in down: about 19% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Clay subsoilBt1 A clay layer about 6 to 11 in down: about 40% clay, high plasticity when wet, grayish brown when moist. Promising
- Clay subsoilBt2best layer A clay layer about 11 to 20 in down: about 40% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Loamy layerBk1 A loam layer about 20 to 27 in down: about 27% clay, moderate plasticity when wet, light gray when moist. Possible
- Loamy layerBk2 A sandy clay loam layer about 27 to 37 in down: about 20% clay, moderate plasticity when wet, very pale brown when moist. Possible
- Loamy layerC A sandy clay loam layer about 37 to 80 in down: about 20% clay, moderate plasticity when wet, very pale brown when moist. Possible
What it looks like raw
The clay subsoil (Bt2), 11 to 20 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; extremely hard, firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed eolian deposits over tertiary aged alluvium derived from igneous, metamorphic and sedimentary rock.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Colorado, in these survey areas: Adams County Area, Parts of Adams and Denver Counties, Colorado; Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
By state: wild clay in Colorado.
USDA, distribution and extent: Eastern Colorado and southeastern Wyoming. The series is of large extent. MLRA 67
USDA, geographic setting: Parent material: pedisediments of Ogallala or similar age in mixed eolian material and alluvium
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Nunn: Strong lead
- Samsil: Strong lead
- Ulm: Strong lead
- Arvada: Strong lead
- Denver: Strong lead
- Englewood: Strong lead
- Manzanola: Strong lead
- Renohill: Strong lead
See it on the map
Open a Platner spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Platner loam, 0 to 3 percent slopes, map unit PlB in Adams County Area, Parts of Adams and Denver Counties, Colorado.
- Official Series Description: Platner(revised 01/2006), established.
- Taxonomic class: Fine, smectitic, mesic Aridic Paleustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.